Surface Protection Points

When utilizing adhesive surface protection products on a job site there is always a small risk of adhesive transfer. Improper installation, high temperatures, high traffic, and surpassing the beneficial ‘remove by’ date can all lead to problems with carpet masks and films. Following are just a few recommendations to keep away from any adhesive transfer.

Always observe the manufacturer’s suggestions when utilizing carpet films. Carpet film usage rankings range from 30 to 60 days. Leaving the film on carpets previous the really useful utilization rating invalidates all manufacturers’ warranty.

Use films made within the USA for one of the best warranty protection and highest quality.

Carpet films use either water based or solvent primarily based adhesives. Water based adhesives are simpler to remove if a problem occurs.

By no means set up adhesive carpet protection on wet or damp carpet.

Never set up adhesive carpet protection over glue down carpet for a minimum of 72 hours to allow the glue to “breathe”.

If carpet has been put in over a newly poured cement slab that is not absolutely cured, avoid using adhesive carpet protection as it can trap the cement moisture and discolor the carpet.

In cases of maximum heat, shorten the recommended time of application by 50%.

As stated on the set up instructions of each film manufacturer, there isn’t a warranty offered for application on wool carpets.

If the above steps are taken, the prospect of any adhesive transfer when using a carpet film is negligible. In the cases where steps have NOT been adopted, one in every of these two issues could occur: 1) sticky adhesive residue on carpet, or 2) discoloration of carpet the place the plastic was used. It is crucial at this step to know the type of adhesive used, water or solvent based.

Water primarily based adhesive film residue simply removes with warm water and can be quickly removed via steam cleaning the carpets. Solvent primarily based adhesive residue may also be removed via steam cleaning nevertheless it may take more than one cleaning to totally remove the adhesive. Citrus cleaners available at any hardware store can typically aid in the removal of solvent based mostly adhesive residue. If additional problems persist, contact your local surface protection provider to discuss other potential solutions.

Discoloration of carpet is caused by the trapping of moisture under the film and the subsequent reaction of the moisture and the chemical substances in the plastic film. Sadly this situation can only be remedied by removal of the affected space of carpet. This situation occurs most commonly in cases where users have carpeted over slabs that were not absolutely cured.

If you beloved this posting and you would like to obtain additional details pertaining to correx sheets kindly go to the web page.