Surface Protection Issues

When using adhesive surface protection products on a job site there may be always a small risk of adhesive transfer. Improper set up, high temperatures, high traffic, and surpassing the advisable ‘remove by’ date can all lead to problems with carpet masks and films. Following are a few suggestions to avoid any adhesive transfer.

Always comply with the manufacturer’s recommendations when using carpet films. Carpet film utilization scores range from 30 to 60 days. Leaving the film on carpets past the really helpful utilization rating invalidates all producers’ warranty.

Use films made in the USA for one of the best warranty protection and highest quality.

Carpet films use either water primarily based or solvent based adhesives. Water primarily based adhesives are easier to remove if a problem occurs.

By no means install adhesive carpet protection on wet or damp carpet.

By no means install adhesive carpet protection over glue down carpet for no less than seventy two hours to permit the glue to “breathe”.

If carpet has been installed over a newly poured cement slab that’s not fully cured, keep away from utilizing adhesive carpet protection as it can trap the cement moisture and discolor the carpet.

In cases of maximum heat, shorten the recommended time of application by 50%.

As stated on the installation directions of every film producer, there isn’t a warranty offered for application on wool carpets.

If the above steps are taken, the prospect of any adhesive transfer when utilizing a carpet film is negligible. Within the cases the place steps have NOT been followed, one among these issues could happen: 1) sticky adhesive residue on carpet, or 2) discoloration of carpet the place the plastic was used. It’s important at this step to know the type of adhesive used, water or solvent based.

Water based adhesive film residue simply removes with warm water and may be quickly removed via steam cleaning the carpets. Solvent based adhesive residue may additionally be removed through steam cleaning nevertheless it may take more than one cleaning to completely remove the adhesive. Citrus cleaners available at any hardware store can generally aid within the removal of solvent based mostly adhesive residue. If further problems persist, contact your local surface protection provider to debate other potential solutions.

Discoloration of carpet is caused by the trapping of moisture under the film and the subsequent response of the moisture and the chemical compounds in the plastic film. Unfortunately this situation can only be remedied by removal of the affected area of carpet. This situation occurs most commonly in cases where users have carpeted over slabs that weren’t absolutely cured.

If you have any concerns regarding where and the best ways to use correx sheets, you can contact us at our own website.